ISO 4437-4:2015 en

Kunststofleidingsystemen voor gasvoorziening - Polyetheen (PE) - Deel 4: Kleppen

73,12 88,48 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 16
Commissie Kunststofleidingsystemen
Gepubliceerd op 15-04-2015
Taal Engels
ISO 4437-4 specifies the characteristics of valves made from polyethylene (PE) for piping systems in the field of the supply of gaseous fuels. It also specifies the test parameters for the test methods referred to in this part of ISO 4437. In conjunction with ISO 4437-1, ISO 4437-2, ISO 4437-3:2014, and ISO 4437-5, it is applicable to PE valves, their joints, and to joints with components of PE and other materials intended to be used under the following conditions: a) the maximum operating pressure, MOP, is based on the design stress determined from the compound MRS divided by the C factor and taking into account RCP requirements; b) temperature of 20 °C as reference temperature; c) operating temperature between -20 °C and +40 °C. This International Standard covers a range of maximum operating pressures and gives requirements concerning colours and additives. It is applicable to bi-directional valves with spigot ends or electrofusion sockets intended to be jointed with PE pipes conforming to ISO 4437-2 without any fittings or with PE fittings conforming to ISO 4437-3:2014. This part of ISO 4437 covers valves for pipes with a nominal outside diameter dn ≤ 400 mm.


ICS-code 75.200
Nederlandse titel Kunststofleidingsystemen voor gasvoorziening - Polyetheen (PE) - Deel 4: Kleppen
Engelse titel Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 4: Valves



Ga naar winkelwagen