ISO 5001:2007 en

Cold-reduced carbon steel sheet for vitreous enamelling

  • Deze norm is ingetrokken sinds 31-07-2012

49,02 59,31 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 8
Commissie Chemische analyse van ijzer en staal
Gepubliceerd op 01-07-2007
Taal Engels
This International Standard applies to cold-reduced carbon steel sheet of commercial and drawing qualities for vitreous enamelling, where the surface of the sheet and chemical composition of the base metal are of prime importance. Sheet for vitreous enamelling is produced in thicknesses of 0,35 mm and thicker (commonly up to 3 mm) and in widths of 600 mm and wider in coils and cut lengths. Sheet for vitreous enamelling less than 600 mm wide may be slit from wide sheet and will be considered sheet. 1.3 Commercial-quality sheet (VE01) is intended for general fabricating purposes where sheet is used in the flat form, or for bending or moderate forming. Drawing-quality sheet (VE02, VE03, VE04 and VE05) is intended for drawing and severe forming. It is furnished to all requirements of this International Standard or, by agreement when ordered, to fabricate an identified part, in which case the mechanical properties of Table 1 do not apply. If strain ageing is to be minimized, grade VE04 or VE05 should be specified. Drawing qualities are identified as follows: VE02 - drawing quality; VE03 - deep-drawing quality; VE04 - deep-drawing quality aluminium-killed (see 4.7); VE05 - extra-deep-drawing quality (stabilized interstitial-free). The designations in 1.3 and 1.4 include the qualities of sheet steel for vitreous enamelling. The designation VE represents "vitreous enamelling" similar to CR "cold reduced". The numbers 01, 02, 03, 04 and 05 are common to other standards, indicating the qualities of commercial, drawing, deep-drawing, deepdrawing aluminium-killed and extra-deep-drawing stabilized interstitial-free.


ICS-code 77.140.50
Engelse titel Cold-reduced carbon steel sheet for vitreous enamelling
Vervangen door



Ga naar winkelwagen