Norm

ISO 521:2011 en

Machineruimers met cylindrische schacht en Morse conische schacht

31,57

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie Gereedschappen
Gepubliceerd op 01-10-2011
Taal Engels
This International Standard specifies the dimensions of machine chucking reamers with cylindrical shanks and Morse taper shanks. It deals with the following types of reamer: - machine chucking reamers with cylindrical shanks in the range from 1,32 mm to 20 mm diameter; - machine chucking reamers with Morse taper shanks in the range from 5,30 mm to 50 mm diameter. For each type of reamer, this International Standard gives two tables, one showing preferred sizes with corresponding dimensions, and the other being a general table set out as functions of diameter steps. Provision is also made for tolerances on lengths, cutting diameters and the diameters of cylindrical shanks.

Details

ICS-code 25.100.30
Nederlandse titel Machineruimers met cylindrische schacht en Morse conische schacht
Engelse titel Machine chucking reamers with cylindrical shanks and Morse taper shanks
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen