Norm

ISO 6362-4:1988 en

Wrought aluminium and aluminium alloy extruded rods/bars, tubes and profiles - Part 4: Extruded profiles - Tolerances on shape and dimensions

  • Deze norm is ingetrokken sinds 28-06-2012

48,19

Over deze norm

Status Ingetrokken
Aantal pagina's 28
Commissie Non-ferro
Gepubliceerd op 28-04-1988
Taal Engels
This part of ISO 6362 specifies among other things the tolerances on cross-sectional dimensions, on lengths, on the permissible contour and angular, twist, flatness tolerances. The tolerances apply to extruded profiles with cross-sectional dimensions given by a circumscribing circle not greater than 600 mm. This part does not apply to rolled and drawn profiles and profiles made from sheet by roll forming, extruded or drawn tube and extruded or drawn rod and bar.

Details

ICS-code 77.150.10
Nederlandse titel Wrought aluminium and aluminium alloy extruded rods/bars, tubes and profiles - Part 4: Extruded profiles - Tolerances on shape and dimensions
Engelse titel Wrought aluminium and aluminium alloy extruded rods/bars, tubes and profiles - Part 4: Extruded profiles - Tolerances on shape and dimensions
Wordt vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen