Norm

ISO 7194:2008 en

Debietmeting van vloeistof in gesloten leidingen - Snelheidsoppervlaktemeetmethode in kolkende of asymetrische leidingcondities in cirkelvormige kanalen met gebruik van stroommeters of Pitot statische buizen

114,67 138,75 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 27
Commissie Debiet- en hoeveelheidsmeting
Gepubliceerd op 15-07-2008
Taal Engels
This International Standard specifies velocity-area methods for measuring flow in swirling or asymmetric flow conditions in circular ducts by means of current-meters or Pitot static tubes. It specifies the measurements required, the precautions to be taken, the corrections to apply, and describes the additional uncertainties which are introduced when a measurement in asymmetric or swirling flow has to be made. Only flows with a negligible radial component are considered, however. Furthermore, it is not possible to make a measurement in accordance with this International Standard if, at any point in the measuring cross-section, the local velocity makes an angle of greater than 40° with the axis of the duct, or where the index of asymmetry Y (defined in Annex F) is greater than 0,15. This International Standard deals only with instruments for measuring local velocity as defined in ISO 3354 and ISO 3966. If Pitot static tubes are used, this International Standard applies only to flows where the Mach number corresponding to local velocities does not exceed 0,25.

Details

ICS-code 17.120.10
75.180.30
Nederlandse titel Debietmeting van vloeistof in gesloten leidingen - Snelheidsoppervlaktemeetmethode in kolkende of asymetrische leidingcondities in cirkelvormige kanalen met gebruik van stroommeters of Pitot statische buizen
Engelse titel Measurement of fluid flow in closed conduits - Velocity-area methods of flow measurement in swirling or asymmetric flow conditions in circular ducts by means of current-meters or Pitot static tubes
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen