Norm

ISO 7452:2013 en

Hot-rolled steel plates - Tolerances on dimensions and shape

73,12

Over deze norm

Status Definitief
Aantal pagina's 14
Gepubliceerd op 15-01-2013
Taal Engels
This International Standard specifies requirements for tolerances for hot-rolled steel plates made on a reversing mill with the following characteristics: a) nominal thickness: 3 mm ≤ t ≤ 400 mm; b) nominal width: w ≥ 600 mm. This International Standard applies to, but is not limited to, steel grades defined in all parts of ISO 630, in ISO 9328-1 to ISO 9328-6 and in ISO 683-1, ISO 683-2, ISO 683-10 and ISO 683-11. This International Standard does not apply to stainless steel. If not otherwise agreed, the tables in Annex A apply to steel grades defined in Annex A of all parts (except Part 1) of ISO 630 or in ISO 9328-1 to ISO 9328-6. If not otherwise agreed, the tables in Annex B apply to steel grades defined in Annex B of all parts (except Part 1) of ISO 630 or in ISO 9328-1 to ISO 9328-6. For steel grades defined in ISO 683-1, ISO 683-2, ISO 683-10 and ISO 683-11, the selection of Annex A or B is done at the time of enquiry and order. This International Standard does not include continuous mill products, custom-made plate, checker plate or bulb plate for flooring or wide flats. This International Standard does not include the following steel products, which are covered by other International Standards: - sheet and strip - refer to ISO/TC 17/SC 12 “Continuous mill flat rolled products”; - tubular products - refer to ISO/TC 5/SC 1 “Steel tubes”.

Details

ICS-code 77.140.50
77.140.70
Engelse titel Hot-rolled steel plates - Tolerances on dimensions and shape
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen