ISO/DIS 17281:2016 en

Kunststoffen - Bepaling van de vervormingstoestand (GIC en KIC) bij gematigde hoge belastingssnelheden (1 m/s)

  • Deze norm is niet direct leverbaar vanuit de NEN-shop.
    Wilt u dit product bestellen neemt u dan contact op met NEN-klantenservice: (015) 2 690 391 of

Over deze norm

Status Ontwerp
Aantal pagina's 31
Commissie Kunststoffen
Gepubliceerd op 12-06-2016
Taal Engels
This International Standard provides guidelines for determining the fracture toughness of plastics in the crackopening mode (Mode I) by a linear elastic fracture mechanics (LEMF) approach, at load-point displacement rates of up to 1 m/s. It supplements ISO 13586 so as to extend its applicability to loading rates somewhat higher than is the case in the scope of the latter International Standard. Fracture testing at high loading rates presents special problems because of the presence of dynamic effects: vibrations in the test system producing oscillations in the recorded quantities, and inertial loads producing forces on the test specimen different from the forces sensed by the test fixture. These effects need either to be controlled and, if possible, reduced by appropriate action, or else to be taken into account through proper analysis of the measured data. The relative importance of such effects increases with increasing testing rate (decreasing test duration). At speeds of less than 0,1 m/s (loading times of greater than 10 ms) the dynamic effects may be negligible and the testing procedure given in ISO 13586 can be applied as it stands. At speeds approaching 1 m/s (loading times of the order of 1 ms) the dynamic effects may become significant but still controllable. The procedure given in ISO 13586 can still be used though with some provisos and these are contemplated in this International Standard. At speeds of several meters per second and higher (loading times markedly shorter than 1 ms) the dynamic effects become dominant, and different approaches to fracture toughness determination are required, which are outside the scope of this International Standard. The general principles, methods and rules given in ISO 13586 for fracture testing at low loading rates remain valid and should be followed except where expressly stated otherwise in this International Standard. The methods are suitable for use with the same range of materials as covered by ISO 13586, i.e.: - rigid and semi-rigid thermoplastic moulding, extrusion and casting materials; - rigid and semi-rigid thermosetting moulding and casting materials. And their compounds containing short fibers of the length ≤7.5mm


ICS-code 83.080.01
Nederlandse titel Kunststoffen - Bepaling van de vervormingstoestand (GIC en KIC) bij gematigde hoge belastingssnelheden (1 m/s)
Engelse titel Plastics - Determination of fracture toughness (GIC and KIC) at moderately high loading rates (1 m/s)



Ga naar winkelwagen