Norm

ISO/TS 10303-1322:2008 en

Industrial automation systems and integration - Product data representation and exchange - Application module: Modified swept solid

  • Deze norm is niet direct leverbaar vanuit de NEN-shop.
    Wilt u dit product bestellen neemt u dan contact op met NEN-klantenservice: (015) 2 690 391 of klantenservice@nen.nl

Over deze norm

Status Definitief
Aantal pagina's 45
Commissie Informatie-integratie en interoperabiliteit
Gepubliceerd op 15-12-2008
Taal Engels
This part of ISO 10303 specifies the application module Modified swept solid. The following are within the scope of this part of ISO 10303: 3D geometry; trimming a swept solid; extruded solids; draft angles; revolved solids; modifying solids created by sweeping a bounded face; items within the scope of application module Basic geometric topology, ISO/TS 10303-1323; items within the scope of application module Swept solid, ISO/TS 10303-1321. The following are outside the scope of this part of ISO 10303: 2D geometry; bounded curves other than edge curves; bounded surfaces other than planes; faces that are not defined as advanced faces; sweeping along a general curve.

Details

ICS-code 25.040.40
Nederlandse titel Industrial automation systems and integration - Product data representation and exchange - Application module: Modified swept solid
Engelse titel Industrial automation systems and integration - Product data representation and exchange - Application module: Modified swept solid

Winkelwagen

Subtotaal:

Ga naar winkelwagen