Norm

ISO/TS 10303-1652:2008 en

Industrial automation systems and integration - Product data representation and exchange - Application module: Basic geometry

  • Deze norm is niet direct leverbaar vanuit de NEN-shop.
    Wilt u dit product bestellen neemt u dan contact op met NEN-klantenservice: (015) 2 690 391 of klantenservice@nen.nl

Over deze norm

Status Definitief
Aantal pagina's 45
Commissie Informatie-integratie en interoperabiliteit
Gepubliceerd op 15-12-2008
Taal Engels
This part of ISO 10303 specifies the application module Basic geometry. The following are within the scope of this part of ISO 10303: geometric primitives; Points, lines, and planes are used to construct more complex geometry that represents the shape of products and features of products. Points, lines, and planes can represent the derived centers of ideal symmetric features of size found in product definitions. 3 Points, curves, and surfaces can represent the derived centers of imperfect features of size measured on real workpieces. geometry used in the construction of two-dimensional and three-dimensional shape representations; items within the scope of application module Elemental geometric shape, ISO/TS 10303-1004. The following are outside the scope of this part of ISO 10303: Specific kinds of curves and surfaces other than line and plane.

Details

ICS-code 25.040.40
Nederlandse titel Industrial automation systems and integration - Product data representation and exchange - Application module: Basic geometry
Engelse titel Industrial automation systems and integration - Product data representation and exchange - Application module: Basic geometry
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen