Norm

NEN-EN 10209:2010 Ontw. en

Koudgewalste platte producten van laag koolstofstaal om te emailleren - Technische leveringsvoorwaarden

  • Deze norm is ingetrokken sinds 17-07-2013

29,20

Over deze norm

Status Ingetrokken
Aantal pagina's 24
Commissie Vervormingsstaal
Gepubliceerd op 01-08-2010
Taal Engels
This European Standard applies to cold rolled non-coated low carton steel flat products in rolled widths equal to or over 600 mm and in thicknesses equal to or less than 3 mm, delivered in sheet, wide strip, slit wide strip or cut lengths obtained from slit wide strip or sheet. It does not apply to cold rolled narrow strip (rolling width < 600 mm) nor to cold rolled flat products for which there is a specific standard, in particular the following: cold-rolled low carbon steel flat products for cold forming (EN 10130); cold-rolled non oriented electrical steel sheet and strip delivered in fully processed state (prEN 10106); cold-rolled electrical non-alloyed steel sheet and strip delivered in semi-processed state (prEN 10126) ; cold-rolled electrical alloyed steel sheet and strip delivered in semi-processed state (prEN 10165); cold reduced blackplate (EN 10205); steel sheet and strip for welded gas cylinders (prEN 10120 ); hot-rolled flat products made of high yield strength steels for cold forming (prEN 10149); cold-rolled uncoated non-alloy mild steel narrow strip for cold forming (prEN 10139); cold-rolled structural steels for general purposes.

Details

ICS-code 77.140.50
Nederlandse titel Koudgewalste platte producten van laag koolstofstaal om te emailleren - Technische leveringsvoorwaarden
Engelse titel Cold rolled low carbon steel flat products for vitreous enamelling - Technical delivery conditions
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen