Norm

NEN-EN 10327:2002 Ontw. en

Continu-dompelverzinkte band en plaat van laag koolstofstaal voor kouddieptrekken - Technische leveringsvoorwaaden

  • Deze norm is ingetrokken sinds 01-07-2004

23,50

Over deze norm

Status Ingetrokken
Aantal pagina's 22
Commissie Vervormingsstaal
Gepubliceerd op 01-04-2002
Taal Engels
This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), aluminium-zinc alloy (AZ) and aluminium-silicon alloy (AS) (see Table 1) with thicknesses of 0,35 mm to 3,0 mm unless otherwise agreed. The thickness is the final thickness of the delivered product after coating. This European Standard applies to strip of all widths and to sheets cut from it (;600 mm width) and cut lengths (< 600 mm width). The products covered by this European Standard are mainly used where cold formability and corrosion resistance are the most important factors. Corrosion resistance of the alloy is proportional to the coating mass (see also 7.2.2)

Details

ICS-code 77.140.10
77.140.50
Nederlandse titel Continu-dompelverzinkte band en plaat van laag koolstofstaal voor kouddieptrekken - Technische leveringsvoorwaaden
Engelse titel Continuously hot-dip coated strip and sheet of low carbon steels for cold forming - Technical delivery conditions
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen