Norm

NEN-EN 10336:2005 2e Ontw. en

Continu dompelbeklede en elektrolytisch beklede plaat en band voor meerfasenstaal voor koud dieptrekken of zetwerk - Technische leveringsvoorwaarden

  • Deze norm is ingetrokken sinds 30-01-2008

29,20

Over deze norm

Status Ingetrokken
Aantal pagina's 25
Commissie Vervormingsstaal
Gepubliceerd op 01-10-2005
Taal Engels
This European Standard specifies requirements for continuously hot-dip coated and electrolytically coated products made of multiphase steels for cold forming (see Tables 1 and 3) coated with zinc (Z and ZE), zinc-iron alloy (ZF) or zinc-nickel alloy (ZN) with thicknesses of 0,35 mm to 3,0 mm, unless otherwise agreed (see 1.2). The thickness is the final thickness of the delivered product after coating. This European Standard applies to strip of all widths and to sheets cut from it (=600 mm width) and cut lengths (< 600 mm width). If agreed at the time of enquiry and order, this European Standard may also be applied to continuously hot-dip coated flat products in thicknesses > 3,0 mm. In this case the mechanical property, adhesion of coating and surface condition requirements should also be agreed at the time of enquiry and order. The products covered by this European Standard are mainly used where cold formability, high strength and corrosion resistance are the most important factors. Corrosion resistance of the coating is proportional to the coating mass (see also 7.3.5) This European Standard is not applicable to - Continuously hot dip coated steel flat products made of low carbon steels (see EN 10327), - continuously hot-dip coated structural steel flat products (see EN 10326), - electrolytically zinc coated cold rolled steel flat products (see EN 10152), - continuously organic coated (coil coated) steel flat products (see EN 10169-1, prEN 10169-2 and EN 10169-3), - electrolytically zinc-nickel coated cold rolled steel flat products (see EN 10271) and - continuously hot-dip coated strip and sheet of steels with higher yield strength for cold forming (see EN 10292).

Details

ICS-code 77.140.50
Nederlandse titel Continu dompelbeklede en elektrolytisch beklede plaat en band voor meerfasenstaal voor koud dieptrekken of zetwerk - Technische leveringsvoorwaarden
Engelse titel Continuously hot-dip coated and electrolytically coated strip and sheet of multiphase steels for cold forming - Technical delivery conditions
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen