Norm

NEN-EN 1115-3:1993 Ontw. en

Kunststof leidingsystemen voor rioleringen onder druk - Met glasvezel versterkte thermoharde kunststoffen (GRP) op polyesterbasis (UP) - Deel 3: Hulpstukken

  • Deze norm is ingetrokken sinds 14-08-1996
  • Deze norm is niet direct leverbaar vanuit de NEN-shop.
    Wilt u dit product bestellen neemt u dan contact op met NEN-klantenservice: (015) 2 690 391 of klantenservice@nen.nl

Over deze norm

Status Ingetrokken
Aantal pagina's 34
Commissie Kunststofleidingsystemen
Gepubliceerd op 01-09-1993
Taal Engels
This part of EN 1115 specifies the characteristics of fittings made from glass-reinforced thermosetting plastics pipes (GRP) based on polyester resin (UP) intended to be used in underground drainage and sewerage under pressure. It also specifies the test parameters for the test methods referred to in this standard. It applies to fittings intended to be used for the conveyance of surface water or sewerage under pressure, both buried and above ground, outside buildings, at temperature up to 45°C. This part specifies the dimensional and performance requirements for bends, branches, reducers, saddles and flanged adaptors made from glass-reinforced thermosetting plastics (GRP), with or without thermoplastic liners. This part applies to fittings fabricated from straight pipe or moulded by filament or tape winding, or by using hand lay-up or contact moulding or hot or cold press moulding.

Details

ICS-code 23.040.20
23.040.45
91.140.80
93.030
Nederlandse titel Kunststof leidingsystemen voor rioleringen onder druk - Met glasvezel versterkte thermoharde kunststoffen (GRP) op polyesterbasis (UP) - Deel 3: Hulpstukken
Engelse titel Plastics piping systems for underground drainage and sewerage under pressure - Glass-reinforced thermosetting plastics (GRP) based on polyester resin (UP) - Part 3: Fittings
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen