Norm

NEN-EN 1115-3:1996 en

Kunststofleidingsystemen voor rioleringen onder druk - Met glasvezel versterkte thermoharde kunststoffen (GVK) op basis van onverzadigde polyesterhars (UP) - Deel 3: Hulpstukken

  • Deze norm is ingetrokken sinds 30-04-2008

61,30

Over deze norm

Status Ingetrokken
Aantal pagina's 24
Commissie Kunststofleidingsystemen
Gepubliceerd op 01-07-1996
Taal Engels
This part of EN 1115 specifies the characteristics of fittings made from glass-reinforced thermosetting plastics pipes (GRP) based on unsaturated polyester resin (GRP-UP) intended to be used in underground drainage and sewerage under pressure. It also specifies the test parameters for the test methods referred to in this standard. It applies to fittings intended to be used for the conveyance of surface water or sewerage under pressure, both buried and above ground, outside buildings, at temperature up to 50°C. This part specifies the dimensional and performance requirements for bends, branches, reducers, saddles and flanged adaptors made from GRP-UP, with or without thermoplastic liners. This part applies to fittings fabricated from straight pipe or moulded by filament or tape winding, or by using hand lay-up or contact moulding or hot or cold press moulding.

Details

ICS-code 23.040.20
23.040.45
91.140.80
93.030
Nederlandse titel Kunststofleidingsystemen voor rioleringen onder druk - Met glasvezel versterkte thermoharde kunststoffen (GVK) op basis van onverzadigde polyesterhars (UP) - Deel 3: Hulpstukken
Engelse titel Plastics piping systems for underground drainage and sewerage under pressure - Glass-reinforced thermosetting plastics (GRP) based on polyester resin (UP) - Part 3: Fittings
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen