Norm

NEN-EN 1115-5:1993 Ontw. en

Kunststof leidingsystemen voor rioleringen onder druk - Met glasvezel versterkte thermoharde kunststoffen (GRP) op polyesterbasis (UP) - Deel 5: Geschiktheid voor de toepassing van het systeem

  • Deze norm is ingetrokken sinds 01-07-1996
  • Deze norm is niet direct leverbaar vanuit de NEN-shop.
    Wilt u dit product bestellen neemt u dan contact op met NEN-klantenservice: (015) 2 690 391 of klantenservice@nen.nl

Over deze norm

Status Ingetrokken
Aantal pagina's 22
Commissie Kunststofleidingsystemen
Gepubliceerd op 01-09-1993
Taal Engels
This part of EN 1115 specifies the characteristics of the fitness for purpose of glass-reinforced thermosetting plastics (GRP) based on polyester resin (UP) piping systems intended to be used in underground drainage and sewerage under pressure. It also specifies the relevant test parameters for the test methods referred to in this part of the System Standard. It applies to the joints to be used in GRP-UP piping systems to be used for the conveyance of surface water or sewerage under pressure, both buried and above ground, outside buildings, at temperatures up to 45°C. This standard specifies initial performance requirements for the following joints for use with GRP-UP pipes for buried and above ground pipelines or pipework systems as a function of the declared nominal pressure rating of the pipeline or system: a) flexible socket and spigot; b) reduced articulation socket and spigot; c) rigid locked socket and spigot; d) cemented socket and spigot; e) bolted flange. This specification is applicable to joints which are or are not intended to be exposed to end thrust loads in service. It covers requirements to prove the design of the joint.

Details

ICS-code 23.040.20
23.040.45
91.140.80
93.030
Nederlandse titel Kunststof leidingsystemen voor rioleringen onder druk - Met glasvezel versterkte thermoharde kunststoffen (GRP) op polyesterbasis (UP) - Deel 5: Geschiktheid voor de toepassing van het systeem
Engelse titel Plastics piping systems for underground drainage and sewerage under pressure - Glas reinforced thermosetting plastics (GRP) based on polyester resin (UP) - Part 5: Fitness for purpose of the system
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen