Norm

NEN-EN 1218-3:1997 Ontw. en

Veiligheid van houtbewerkingsmachines - Pennenbanken - Deel 3: Machines met handbediende schuiftafels voor het zagen van pen/gat-verbindingen

  • Deze norm is ingetrokken sinds 14-11-2001

35,70

Over deze norm

Status Ingetrokken
Aantal pagina's 46
Commissie Houtbewerkingsmachines
Gepubliceerd op 01-03-1997
Taal Engels
Sets out requirements and describes the methods for the removal of hazards or the measures that shall be taken to limit risks on hand fed machines with sliding table for cutting roof timber frames, designed to cut solid wood (mainly structural timbers). The workpiece is fed past the tools by hand-feed. For the purpose of this standard the hand fed machines with sliding table for cutting roof timber frames is hereinafter referred to as the machine. This standard covers all the hazards relevant to the machine. This standard does not apply to: - machines where the tenon is produced by means of milling tools - machines where the design speed of any tool spindle exceeds 6000 r/min - machines where the cuts are made on both ends of the workpiece during one cycle - combined machines used for tenoning (see prEN 940) - tenoning attachment on a vertical spindle moulding machine (see prEN 848-1).

Details

ICS-code 79.120.10
Nederlandse titel Veiligheid van houtbewerkingsmachines - Pennenbanken - Deel 3: Machines met handbediende schuiftafels voor het zagen van pen/gat-verbindingen
Engelse titel Safety of woodworking machines - Tenoning machines - Part 3: Hand fed machines with sliding table for cutting roof timber frames
Vervangen door
Normatieve verwijzingen
  • 98/37/EG, Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen