Norm

NEN-EN 1254-1:2007 Ontw. en

Koper en koperlegeringen - Hulpstukken - Deel 1: Hulpstukken met uiteinden voor capillaire of hardsoldeerverbinding aan koperen buizen

35,70

Over deze norm

Status Ontwerp
Aantal pagina's 43
Gepubliceerd op 01-05-2007
Taal Engels
This European Standard specifies materials, assembly dimensions and tolerances and test requirements for fittings of copper and copper alloys with or without plating or coating. This part of EN 1254 specifies connection end dimensions of capillary soldering and brazing ends in the size range 6 mm to 108 mm for the purposes of joining copper tubes intended for use in hot or cold or combined hot and cold water, heating and cooling systems, natural gas and liquefied petroleum gas systems. Permissible operating temperatures and maximum operating pressures are also established. This standard is applicable to capillary fittings for joining the following tubes: - Copper tubes to EN 1057; - Pre-insulated copper tubes to EN 13349. Fittings may also be suitable for joining other tubes provided the capillary joint with the specified tube meets the requirements of this standard. Fittings may comprise a combination of any of the end types specified in EN 1254 or other standards, provided they are suitable for the fluid/gas being conveyed. The standard establishes a designation system for the fittings.

Details

ICS-code 23.040.40
Nederlandse titel Koper en koperlegeringen - Hulpstukken - Deel 1: Hulpstukken met uiteinden voor capillaire of hardsoldeerverbinding aan koperen buizen
Engelse titel Copper and copper alloys - Plumbing fittings - Part 1: Fittings with ends for capillary soldering or capillary brazing to copper tubes
Vervangt
Normatieve verwijzingen
  • 89/106/EEG, Bouwproducten

Winkelwagen

Subtotaal:

Ga naar winkelwagen