Norm

NEN-EN 13803-2:2004 Ontw. en

Railtoepassingen - Spoor - Ontwerpparameters voor het uitlijnen van spoor - Spoorbreedte 1435 mm en groter - Deel 2: Wissels en kruisingen en vergelijkbare uitlijnontwerpsituaties met abrupte verandering van boogstraal

  • Deze norm is ingetrokken sinds 17-01-2007

35,70

Over deze norm

Status Ingetrokken
Aantal pagina's 42
Commissie Spoorwegen
Gepubliceerd op 01-05-2004
Taal Engels
This European Standard specifies the rules and values for the track alignment design parameters used to determine the maximum operating speeds over tracks with abrupt changes in curvature and, consequently, abrupt changes of cant deficiency. Such conditions occur in the following situations : - in the diverging tracks in switch and crossing layouts ; - when it is not practical to design an alignment with transition curves ; - if the length of a transition curve is less than the minimum required for plain line track. This European Standard presupposes that the homologation of the operating vehicles will be valid and specified for conditions corresponding to the limiting values specified in this European Standard. This European Standard is applicable to abrupt changes in curvature in switch and crossing layouts and plain lines with track gauges of 1435 mm and wider. Annex C is applicable to track gauges wider than 1 435 mm. This European Standard specifies the requirements for preventing buffer locking. The limiting values specified in this European Standard, when applied at the switch toe, are for switches with tangential geometry (as defined in 8.2.1 of prEN 13232-1). This European Standard does not apply to urban and suburban lines. This European Standard is not applicable to track alignment requirements for tilting body vehicles. However, Annex G draws the designer's attention to the consequences and the restrictions imposed when tilting vehicles are operated over switch and crossing layouts and alignments without transitions curves.

Details

ICS-code 45.080
93.100
Nederlandse titel Railtoepassingen - Spoor - Ontwerpparameters voor het uitlijnen van spoor - Spoorbreedte 1435 mm en groter - Deel 2: Wissels en kruisingen en vergelijkbare uitlijnontwerpsituaties met abrupte verandering van boogstraal
Engelse titel Railway applications - Track alignment design parameters - Track gauges 1435 mm and wider - Part 2: Switches and crossings and comparable alignment design situations with abrupt changes of curvature
Vervangen door
Normatieve verwijzingen
  • 96/48/EG, Hogesnelheidstreinen

Winkelwagen

Subtotaal:

Ga naar winkelwagen