Norm

NEN-EN 13957:2007 Ontw. en

Aluminium en aluminiumlegeringen - Geëxtrudeerde ronde, beklede buizen voor algemene toepassingen - Specificatie

  • Deze norm is ingetrokken sinds 05-11-2008

23,50

Over deze norm

Status Ingetrokken
Aantal pagina's 16
Gepubliceerd op 01-05-2007
Taal Engels
This European Standard specifies the tolerances on dimensions and form for aluminium and aluminium alloys extruded, round porthole tubes with an outside diameter (OD) of over 2 mm up to and including 50 mm supplied in coil form or in straight lengths cut from coiled material: see Figure 1. This European Standard mainly applies to extruded tube for general engineering applications made in the standard 1xxx and 3xxx series of alloys. The use of this European Standard for non-standardised 1xxx/3xxx alloys or alloys from other series (e.g. 5xxx or 6xxx) is subject to agreement between supplier and purchaser. This European Standard only applies to: - tube produced by the porthole/bridge method, extruded in coil form to the final dimensions required; - tube as above but delivered in straight lengths cut from coiled material. This European Standard does not apply to: - extruded tubes produced by the seamless, die/mandrel method; - tubes extruded in straight lengths i.e. not coiled.

Details

ICS-code 77.150.10
Nederlandse titel Aluminium en aluminiumlegeringen - Geëxtrudeerde ronde, beklede buizen voor algemene toepassingen - Specificatie
Engelse titel Aluminium and aluminium alloys - Extruded round, coiled tube for general applications - Specification
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen