Norm

NEN-EN 14294:2010 en

Lijmen voor materialen voor leer en schoeisel - Voorbehandeling van gelijmde proefstukken door vormingsprocessen

49,30

Over deze norm

Status Definitief
Aantal pagina's 13
Gepubliceerd op 01-02-2010
Taal Engels
This European Standard specifies procedures for the preparation of test pieces comprising adhesive coated leather or other footwear upper material onto which a soling material is moulded directly. The procedures described simulate direct vulcanising of rubber, injection moulding of thermoplastics and reaction moulding of polyurethane. The prepared test pieces are suitable for the test procedures described in EN 1392, to meet the requirements of EN 15307. SAFETY STATEMENT- Persons using this document should be familiar with the normal laboratory practice, if applicable. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any regulatory conditions. ENVIRONMENTAL STATEMENT- It is understood that some of the material permitted in this standard may have negative environmental impact. As technological advantages lead to acceptable alternatives for these materials, they will be eliminated from this standard to the extent possible. At the end of the test, the user of the standard should take care to carry out an appropriate disposal of the wastes, according to local regulation.

Details

ICS-code 83.180
Nederlandse titel Lijmen voor materialen voor leer en schoeisel - Voorbehandeling van gelijmde proefstukken door vormingsprocessen
Engelse titel Adhesives for leather and footwear materials - Preparation of bonded test pieces by moulding-on processes
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen