Norm

NEN-EN 14598-3:2003 Ontw. en

Versterkte thermohardende vormmaterialen - Specificatie voor platen van persgietmengsels (SMC) en massapersgietmengsels (BMC) - Deel 3: Bijzondere eisen

  • Deze norm is ingetrokken sinds 12-05-2005

23,50

Over deze norm

Status Ingetrokken
Aantal pagina's 21
Commissie Kunststoffen
Gepubliceerd op 01-01-2003
Taal Engels
This part of prEN 14598 specifies the requirements for physical and chemical properties of Sheet moulding Compounds (SMC) and Bulk Moulding Compound (BMC) and compression or injection moulded specimens. The selection in this part is limited to those materials the composition and properties of which are significantly different. Furthermore the selection is limited to those materials which are of more general technical and / or economical importance. The properties which are used for the characterization of the moulding compounds, the test methods and the test conditions are based on part 2 of this standard. The list of properties is selected, initially, from those general test methods found in ISO 10350-1, Plastics;Acquisition and presentation of comparable single-point data - Part 1 : Moulding materials. The moulding compounds are divided into types corresponding to their composition and properties. The designation of the types of moulding compounds is based on part 1 "Designation and basis for specifications" of this standard.

Details

ICS-code 83.080.10
83.120
Nederlandse titel Versterkte thermohardende vormmaterialen - Specificatie voor platen van persgietmengsels (SMC) en massapersgietmengsels (BMC) - Deel 3: Bijzondere eisen
Engelse titel Reinforced thermosetting moulding compounds - Specification for Sheet Moulding Compound (SMC) and Bulk Moulding Compound (BMC) - Part 3: Specific requirements
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen