NEN-EN 1537:2009 Ontw. en

Uitvoering van bijzonder geotechnisch werk - Grondankers

  • Deze norm is ingetrokken sinds 16-07-2013


Over deze norm

Status Ingetrokken
Aantal pagina's 54
Commissie Geotechniek
Gepubliceerd op 01-12-2009
Taal Engels
This Standard applies to the installation and monitoring of permanent and temporary ground anchors. This standard covers anchors which are able to be stressed and are able to be tested in accordance with EN ISO 22477-5. An anchor consists of an anchor head, a free anchor length and a fixed anchor length which is bonded to the ground by grout. Typical ground and compression type anchors are shown in Figures 1 and 2. The load capacity of every anchor shall be tested in situ. The term "ground" is taken to encompass both soil and rock. The planning and design of ground anchors calls for experience and knowledge in this specialised field and although these topics are covered briefly in EN 1997-1 Eurocode 7: Geotechnical Design, Part 1: General Rules. The installation and testing phases require skilled and qualified labour and supervision. This Standard cannot replace the knowledge of specialist personnel and the expertise of experienced contractors required to apply the Standard. This Standard does not address alternative systems of anchoring such as tension piles, screw anchors, mechanical anchors, soil nails, expander anchors or deadman anchors. If one of these is used as an anchor (in accordance with EN1537) it shall fulfil all of the requirements of sub-clauses 1.2, 1.3 and 1.4.


ICS-code 93.020
Nederlandse titel Uitvoering van bijzonder geotechnisch werk - Grondankers
Engelse titel Execution of special geotechnical works - Ground anchors
Vervangen door



Ga naar winkelwagen