Norm

NEN-EN 15502-1:2010 2e Ontw. en

Met gas gestookte centrale verwarmingsketels - Deel 1: Algemene eisen en beproevingen

  • Deze norm is ingetrokken sinds 16-12-2011

59,10

Over deze norm

Status Ingetrokken
Aantal pagina's 140
Commissie CV- en warmwatertoestellen
Gepubliceerd op 01-08-2010
Taal Engels
This part of prEN 15502, Generic Standard, specifies the common requirements and test methods concerning, in particular the construction, safety, fitness for purpose, and rational use of energy, as well as the classification and marking of gas-fired central heating boilers that are fitted with atmospheric burners, fan assisted atmospheric burners or fully premixed burners, and are hereafter referred to as “boilers”. This European Standard is to be used in conjunction with the specific Part 2-1 and following ones. This European Standard applies to boilers of types B and C, according to CEN/TR 1749: a) that use one or more combustible gases of the three gas families at the pressures stated in EN 437; b) where the temperature of the heat transfer fluid does not exceed 105 °C during normal operation; c) where the maximum operating pressure in the water circuit does not exceed 6 bar; d) which can give rise to condensation under certain circumstances; e) which are declared by the manufacturer to be "condensing boilers"; f) which are declared by the manufacturer to be "low temperature boilers"; g) which are intended to be installed in a partially protected place; h) which are intended to produce hot water either by the instantaneous or storage principle, the whole being marketed as a single unit. For applications within the scope of the PED further requirements may be necessary (e.g. situations where the maximum allowable temperature exceeds 110 °C, or where volume times maximum allowable pressure is over 50 bar per litres) This European Standard applies to boilers designed for sealed water systems or for open water systems. This general standard and the specific standards (see Part 2) provide requirements for boilers with known constructions. For boilers with any alternative constructions, which might not fully be covered by this standard or a specific standard, the risk associated with this alternative construction shall be assessed. An example of an assessment methodology, based upon risk assessment and which covers the essential requirements of the Gas Appliance Directive, is given in Clause 11. This European Standard covers only type testing.

Details

ICS-code 27.060.30
91.140.10
Nederlandse titel Met gas gestookte centrale verwarmingsketels - Deel 1: Algemene eisen en beproevingen
Engelse titel Gas-fired heating boilers - Part 1: General requirements and tests
Vervangt
Vervangen door
Normatieve verwijzingen
  • 90/396/EEG, Gastoestellen

Winkelwagen

Subtotaal:

Ga naar winkelwagen