Norm

NEN-EN 1555-2:2009 Ontw. en

Kunststofleidingsystemen voor gasvoorziening - Polyetheen (PE) - Deel 2: Buizen

  • Deze norm is ingetrokken sinds 14-09-2010

23,50

Over deze norm

Status Ingetrokken
Aantal pagina's 21
Commissie Kunststofleidingsystemen
Gepubliceerd op 01-02-2009
Taal Engels
This part of EN 1555 specifies the characteristics of pipes made from polyethylene (PE) for piping systems in the field of the supply of gaseous fuels. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with the other parts of EN 1555 (see Foreword) it is applicable to PE pipes, their joints and to joints with components of PE and other materials intended to be used under the following conditions: a) a maximum operating pressure, MOP, up to and including 10 bar 1); b) an operating temperature of 20 °C as reference temperature. EN 1555 covers a range of maximum operating pressures and gives requirements concerning colours and additives. It covers three types of pipe: - PE pipes (outside diameter dn) including any identification stripes; - PE pipes with co-extruded layers on either or both the outside and/or inside of the pipe (total outside diameter dn) as specified in Annex B, where all layers have the same MRS rating; - PE pipes (outside diameter dn) with a peelable, contiguous thermoplastics additional layer on the outside of the pipe (‘coated pipe’) as specified in Annex C.

Details

ICS-code 23.040.20
91.140.40
Nederlandse titel Kunststofleidingsystemen voor gasvoorziening - Polyetheen (PE) - Deel 2: Buizen
Engelse titel Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 2: Pipes
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen