Norm

NEN-EN 1555-3:2009 Ontw. en

Kunststofleidingsystemen voor gasvoorziening - Polyetheen (PE) - Deel 3: Hulpstukken

  • Deze norm is ingetrokken sinds 14-09-2010

29,20

Over deze norm

Status Ingetrokken
Aantal pagina's 27
Commissie Kunststofleidingsystemen
Gepubliceerd op 01-02-2009
Taal Engels
This part of EN 1555 specifies the characteristics of fusion fittings made from polyethylene (PE) as well as of mechanical fittings for piping systems in the field of the supply of gaseous fuels. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with the other parts of EN 1555 (see Foreword), it is applicable to PE fittings, their joints and to joints with components of PE and other materials intended to be used under the following conditions: a) a maximum operating pressure, MOP, up to and including 10 bar 1); b) an operating temperature of 20 °C as reference temperature. EN 1555 covers a range of maximum operating pressures and gives requirements concerning colours and additives. This standard is applicable for fittings of the following types: a) electrofusion socket fittings; b) electrofusion saddle fittings; c) spigot end fittings (for butt fusion using heated tools and electrofusion socket fusion); d) mechanical fittings. The fittings can e.g. be in the form of couplers, equal and reduced tees, reducers, bends or caps.

Details

ICS-code 23.040.45
91.140.40
Nederlandse titel Kunststofleidingsystemen voor gasvoorziening - Polyetheen (PE) - Deel 3: Hulpstukken
Engelse titel Plastics piping systems for the supply of gaseous fuels - Polyethylene(PE) - Part 3: Fittings
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen