Norm

NEN-EN 15654-1:2015 3e Ontw. en

Railtoepassingen - Meting van wiel en asbelastingen - Deel 1: Interoperabele spoorgebonden meetinrichtingen voor rijdende voertuigen

35,70

Over deze norm

Status Ontwerp
Aantal pagina's 38
Commissie Spoorwegen
Gepubliceerd op 01-09-2015
Taal Engels
The scope of this European Standard is restricted to the measurement of quasi-static vertical wheel forces and therefrom derived quantities on vehicles in service operation. Derived quantities can be: - axle loads; - side to side load differences of a wheel set, bogie, vehicle or train set; - overall weight of vehicle or train set; - mean axle load of a vehicle or train set. This standard is not concerned with the evaluation of: - dynamic wheel force or derived quantities; - wheel condition (i.e. shape, profile, flats); - lateral wheel force; - combination of lateral and vertical wheel forces. The standard defines accuracy classes for measurements to be made at any speed greater than 5 km/h within the calibrated range, which may be up to line speed. The aim of this standard is to obtain measurement results that give representative values for the load distribution of a running vehicle, which under ideal conditions will be similar to what can be obtained from a standing vehicle. This standard does not impose any restrictions on the types of vehicles that can be monitored, or on which networks or lines the measuring system can be installed. The standard lays down minimum technical requirements and the metrological characteristics of a system for measuring and evaluating a range of vehicle loading parameters. Also defined are accuracy classes for the parameters measured and the procedure for verifying the calibration. The measuring system proposed in this standard should not be considered as being safety critical. If the measuring system is connected to track signalling, a train monitoring or a train control system then requirements that are not part of this standard may apply. Measuring systems complying with this standard have the potential to enhance rail safety. However, the current operating and maintenance procedures rather than this standard are mandatory for ensuring safety levels in European rail networks.

Details

ICS-code 45.060.01
Nederlandse titel Railtoepassingen - Meting van wiel en asbelastingen - Deel 1: Interoperabele spoorgebonden meetinrichtingen voor rijdende voertuigen
Engelse titel Railway applications - Measurement of vertical forces on wheels and wheelsets - Part 1: Interoperable on-track measurement sites for vehicles in service
Vervangt
Normatieve verwijzingen
  • 2008/57/EG, Interoperabiliteit spoorwegsystemen

Winkelwagen

Subtotaal:

Ga naar winkelwagen