Over deze norm
This standard describes the specific "Design for PRM Use" requirements applying to rolling stock on the trans-European network (TEN) covered by the TSI for PRM and the assessment of those requirements. The following are valid for this standard: - the definitions and requirements describe specific aspects of "Design for PRM Use" required by people with reduced mobility as defined in TSI PRM; - people with reduced mobility as defined in TSI PRM; - this standard defines elements which are universally valid for obstacle free travelling including toilets, elements for sitting/standing/moving and passageways/internal doors. The definitions and requirements of this standard are to be used for rolling stock applications; - this part of the standard covers those requirements relating to "Toilets"; - the standard only refers to aspects of accessibility for PRM passengers. It does not define general requirements and general definitions for specific components and systems; - this standard assumes that the vehicle is in the defined operating condition, any damages or operating failures will not be taken into account when assessing these requirements; - where minimum or maximum dimensions are quoted these are absolute NOT nominal requirements. The following areas of "Equipment and Components" from TSI PRM are covered in three parts: - Part 1 contains: - Toilets; - Part 2 contains: - Handholds; - Seats; - Wheelchair spaces; - Part 3 contains: - Passage ways; - Internal Doors. This standard describes these areas with clear and consistent terms and definitions. Measurement methods and/or assessment procedures needed to establish a clear pass/fail assessment are provided where necessary.
|Nederlandse titel||Railtoepassingen - Ontwerp voor PRM inrichtingen en onderdelen aan boord van rollend materieel - Deel 1: Toiletten|
|Engelse titel||Railway Applications - Design for PRM Use Equipment and Components onboard Rolling Stock - Part 1: Toilets|
|Vervangen door||Normatieve verwijzingen||