Over deze norm
This European Standard describes the specific ‘Design for PRM Use’ requirements applying to rolling stock on the trans-European network (TEN) covered by the TSI for PRM and the assessment of those requirements. The following are valid for this standard. - The definitions and requirements describe specific aspects of ‘Design for PRM Use’ required by people with reduced mobility as defined in TSI PRM. - This standard defines elements which are universally valid for obstacle free travelling including toilets, elements for sitting/standing/moving and passageways/internal doors. The definitions and requirements of this standard shall be used for rolling stock applications. - This part of the standard covers those requirements relating to "Toilets". - The standard only refers to aspects of accessibility for PRM passengers it does not define general requirements and general definitions for specific components and systems. - This standard assumes that the vehicle is in the defined operating condition, any damages or operating failures will not be taken into account when assessing these requirements. - Where minimum or maximum dimensions are quoted these are absolute NOT nominal requirements. The following areas of ‘Equipment and Components’ from TSI PRM are covered in 3 parts which contain: - Part 1 - Toilets - Part 2 - Handholds - Seats - Wheelchair spaces - Part 3 - Passageways - Internal Doors This standard will describe these areas with clear and consistent terms and definitions. Measurement methods and/or assessment procedures needed to establish a clear pass/fail assessment are provided where necessary.
|Nederlandse titel||Railtoepassingen - Ontwerp voor PRM gebruik - Apparatuur en onderdelen aan boord van rollend materieel - Deel 3: Doorgangen en binnendeuren|
|Engelse titel||Railway applications - Design for PRM use - Equipment and components onboarding Rolling Stock - Part 3: Passageways and internal doors||Normatieve verwijzingen||