NEN-EN 1845:2004 Ontw. en

Machines voor het vervaardigen van schoeisel - Machines voor het vormen van schoeisel - Veiligheidseisen

  • Deze norm is ingetrokken sinds 17-01-2008


Over deze norm

Status Ingetrokken
Aantal pagina's 79
Gepubliceerd op 01-10-2004
Taal Engels
This Standard applies to footwear moulding machines which are intended for use in the shoe industry for the production of footwear and footwear components. These machines are: - direct-on sole moulding machines (see figures 1, 2, 3) - unit sole and footwear component moulding machines (see figure 4 - 10) - full shoe and boot moulding machines (see figure 11). This Standard specifies safety requirements for construction, transport, installation, adjustment, setting, teaching or process change-over, operation, cleaning, maintenance, decommissioning, dismantling and, as far as safety is concerned, disposal for machines mentioned in l.1. It deals with all significant hazards, hazardous situations and events relevant to footwear moulding machines , when they are used as intended and under the conditions foreseen by the manufacturer (see clause 4). The following machines are excluded from the scope of this Standard unless used for direct-on sole moulding or reaction moulding: - moulding machines with static injection units and static mould - stations (clamping units), - moulding machines with static metering and mixing units and mobile stations with linear configuration (mould carriers). The standard does not deal with hazards created by the mixing and metering unit The use of machines within the scope of this Standard in industries other than those specified in 1.1 may give rise to hazards not considered during its preparation. This standard also applies to the following additional equipment for material handling and operation which are an integral part of the machine: spraying devices, injection units, casting units, nozzle cleaners, sprue pullers, mould front edge cleaners, activating devices, robots and equipment for preparatory and subsequent treatment (see fig. M.1). This standard assumes the machines - are operated by adequately trained persons - are used with adequate workplace lighting (see prEN 12464). This document is not applicable to footwear moulding machines which are manufactured before the date of publication of this standard by CEN.


ICS-code 59.140.40
Nederlandse titel Machines voor het vervaardigen van schoeisel - Machines voor het vormen van schoeisel - Veiligheidseisen
Engelse titel Footwear manufacturing machines - Footwear moulding machines - Safety requirements
Vervangen door
Normatieve verwijzingen
  • 2006/42/EG, Machines



Ga naar winkelwagen