Norm

NEN-EN 1870-14:2008 en

Veiligheid van houtbewerkingsmachines - Cirkelzagen - Deel 14: Verticale plaatzaagmachines

  • Deze norm is ingetrokken sinds 22-10-2009

86,00

Over deze norm

Status Ingetrokken
Aantal pagina's 56
Commissie Houtbewerkingsmachines
Gepubliceerd op 01-01-2008
Taal Engels
This document deals with the significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to manually loaded and unloaded vertical panel sawing (with or without integrated feed) machines fitted with: the facility for scoring; an angle cutting device; a middle support device; a programmable stop for parallel vertical cuts; the facility for grooving with a width of at most 20 mm in one pass by using a milling tools, hereinafter referred to as "machines" when they are used as intended and under the conditions foreseen by the manufacturer.

Details

ICS-code 79.120.10
Nederlandse titel Veiligheid van houtbewerkingsmachines - Cirkelzagen - Deel 14: Verticale plaatzaagmachines
Engelse titel Safety of woodworking machines - Circular sawing machines - Part 14: Vertical panel sawing machines
Vervangt
Vervangen door
Normatieve verwijzingen
  • 2006/42/EG, Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen