Norm

NEN-EN 1881-1:1995 Ontw. en

Produkten en systemen voor de bescherming en reparatie van betonconstructies - Beproevingsmethoden - Deel 1: Uittrekproef - Ongescheurd beton

  • Deze norm is ingetrokken sinds 12-02-2004

23,50

Over deze norm

Status Ingetrokken
Aantal pagina's 10
Commissie Beton
Gepubliceerd op 01-04-1995
Taal Engels
Specifies the conditions for carrying out a pull-out test on a reinforcing steel (rebar) sealed in a concrete block, using the product to be tested. This test is performed to: - characterize the product by a minimum level of bonding strength between product and rebar. - verify if the bonding strength between product and concrete is in accordance with the ENV 1992-1 requirements by considering the rebar and product system as a rebar itself. It applies to products based on hydraulic binders or synthetic resins. It does not include those products intended to seal high tensile steels as used for prestressed reinforcements. It is the responsability of the manufacturing of the product to state the arrangements and requirements for carrying out the sealing: floor, wall, ceiling. As requested by the manufacturer of the product, the test shall be carried out either on dry surfaces or on wet surfaces or on both types of surface.

Details

ICS-code 91.100.30
Nederlandse titel Produkten en systemen voor de bescherming en reparatie van betonconstructies - Beproevingsmethoden - Deel 1: Uittrekproef - Ongescheurd beton
Engelse titel Products and systems for the protection and repair of concrete structures - Test methods - Part 1: Pull-out test - Uncracked concrete
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen