Norm

NEN-EN 201:1996 Ontw. en

Machines voor rubber en kunststoffen - Spuitgietmachines - Veiligheidseisen

  • Deze norm is ingetrokken sinds 01-03-1997
  • Deze norm is niet direct leverbaar vanuit de NEN-shop.
    Wilt u dit product bestellen neemt u dan contact op met NEN-klantenservice: (015) 2 690 391 of klantenservice@nen.nl

Over deze norm

Status Ingetrokken
Aantal pagina's 54
Commissie Rubber- en kunststofmachines
Gepubliceerd op 01-03-1996
Taal Engels
Specifies the essential safety requirements for injection moulding machines for the processing of plastics and/or rubber. All hazards listed in caluse 4 are covered by this standard. The following machines are excluded: - machines on which the clamping unit can only be opeated by the physical force of the operator - machines for reaction injection moulding (RIM, see prEN 1612-1 and prEN 1212-2). - compression and transfer moulding machines (see EN 289) - direct on sole injection moulding machines and full boot injection moulding machines (Wellington type boots with textile inserts) (see prEN 1845). The safety requirements for the interaction between injection moulding machines and ancillary equipment are specified. The safety requirements for the ancillary equipment itself are not specified. This standard does not cover requirements for the design of an exhaust system. This standard applies to injection moulding machines manufactured after the date of issue of the standard.

Details

ICS-code 83.200
Nederlandse titel Machines voor rubber en kunststoffen - Spuitgietmachines - Veiligheidseisen
Engelse titel Rubber and plastics machines - Injection moulding machines - Safety requirements
Vervangt
Vervangen door
Normatieve verwijzingen
  • 98/37/EG, Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen