Norm

NEN-EN 50340:2010 en

Hydraulische toestellen voor het knippen van kabels - Toestellen voor gebruik in elektrische installaties met een nominale spanning tot 30 kV wisselstroom

61,30

Over deze norm

Status Definitief
Aantal pagina's 28
Commissie Werkvoorschriften
Gepubliceerd op 01-06-2010
Taal Engels
This European Standard is applicable to cable cutting devices to be used to verify that a cable is dead in accordance with the rules given in EN 50110-1. The following limits apply to the cable cutting devices: - pressure less than 1 000 bar or pressure (bar) x volume (l) less than 10 000; - fluid outside the categories listed in Article 9 Group 1 (explosive, extremely flammable, highly flammable, flammable (where the maximum allowable temperature is above flashpoint), very toxic, toxic, oxidizing) of the Pressure Equipment Directive. Cable cutting devices specified in this standard are for use on systems with nominal voltage up to 30 kV AC and nominal frequencies up to 60 Hz and shall only be suitable for operation by foot or by hand. This European Standard does not deal with motorised cable cutting devices. For devices to be used on systems with nominal voltages above 30 kV AC this standard should be used as a guide but additional requirements and tests shall be agreed between manufacturer and customer to provide for an equivalent level of safety. These devices are not designed to be used on cables with special armour, or with steel wires or steel tapes more than 1 mm in diameter or thickness.

Details

ICS-code 13.260
29.240.20
29.260.99
Nederlandse titel Hydraulische toestellen voor het knippen van kabels - Toestellen voor gebruik in elektrische installaties met een nominale spanning tot 30 kV wisselstroom
Engelse titel Hydraulic cable cutting devices - Devices to be used on electrical installations with nominal voltage up to AC 30 kV
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen