NEN-EN 50617-1:2013 Ontw. en

Spoorwegen en soortgelijk geleid vervoer - Basisparameters voor treindetectiesystemen - Deel 1: Spoorstroomlopen

  • Deze norm is ingetrokken sinds 22-05-2015

47,00 56,87 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 90
Commissie Elektrisch materieel, systemen en elektronische toepassingen voor spoorwegen en soortgelijk geleid vervoer
Gepubliceerd op 15-07-2013
Taal Engels
NEN-EN 50617-1 specifies the technical parameters of track circuits associated with the disturbing current emissions limits for RST in the context of interoperability defined in the form of Frequency Management. The limits for compatibility between rolling stock and track circuits currently proposed in this standard allow provision for known interference phenomena linked to traction power supply and associated protection (over voltage, short-circuit current and basic transient effects like in-rush current and power cut-off). These effects are assessed using modelling tools that have been verified by the past European research project RAILCOM. This European Standard is intended to be used to assess compliance of track circuits equipment and other forms of train detection systems using the rails as part of their detection principles, in the context of the European Directive on the interoperability of the trans-European railway system and the associated technical specification for interoperability relating to the control-command and signalling track-side subsystems. The European Standard describes technical parameters to consider for achieving the compatibility of the track circuit with the emissions limits defined in the frequency management for rolling stock. These parameters are structured and allocated according to their basic references as follows: - Technical track circuit parameters; - Train based parameters; - Track based parameters; - Environmental and other parameters including EMC. Each parameter is defined by a short general description, the definition of the requirement, the relation to other standards and a procedure to show the fulfilment of the requirement as far as necessary. An overview of the safety relevance of each parameter is given - in the The immunity limits of the track circuits installed on non-interoperable lines, or on interoperable lines built before the publication date of this document, are not defined in this European Standard and remain the responsibility of individual infrastructure managers, NSAs and/or suppliers of train detection systems. In this case, the limits for compatibility are usually given in the infrastructure registers and/or the notified national rules. This European Standard is applicable to track circuits installed on all traction power supply lines, including non-electrified lines. However, for track circuits intended to be installed only on non-electrified lines, some parameters may be not applicable.context of this European Standard - in a separate table.


ICS-code 29.280
Nederlandse titel Spoorwegen en soortgelijk geleid vervoer - Basisparameters voor treindetectiesystemen - Deel 1: Spoorstroomlopen
Engelse titel Railways applications - Basic parameters of train detection systems - Part 1: Track circuits
Vervangen door



Ga naar winkelwagen