Norm

NEN-EN 574:1997+A1:2008 en

Veiligheid van machines - Tweehandenbediening - Functionele aspecten - Grondslagen voor het ontwerp

61,30

Over deze norm

Status Definitief
Aantal pagina's 31
Commissie Machineveiligheid
Gepubliceerd op 01-07-2008
Taal Engels
This standard Specifies the safety requirements of a two-hand control device and its logic unit as defined in 3.1. Describes the main characteristics of two-hand control devices for the achievement of safety and sets out combinations of functional characteristics for three types. Does not apply to devices intended to be used as enabling devices, hold to run devices and as special control devices. This standard does not specify with which machines two-hand control devices shall be used. It also does not specify which types of two-hand-control device shall be used. Moreover it does not specify the distance between the two-hand control device and the danger zone (see 9.8). The standard provides requirements and guidance on the design and selection (based on a risk assessment) of two-hand control devices including their assessment, the prevention of defeat and the avoidance of faults. The standard also provides requirements and guidance for two-hand control devices containing a programmable electronic system (see 7). This standard applies to all two-hand control devices, independent of the energy used, including: - Two-hand control devices which are or are not integral parts of a machine; - Two-hand control devices which consist of one or more than one separate elements.

Details

ICS-code 13.110
13.110-10
Nederlandse titel Veiligheid van machines - Tweehandenbediening - Functionele aspecten - Grondslagen voor het ontwerp
Engelse titel Safety of machinery - Two-hand control devices - Functional aspects - Principles for design
Vervangt
Normatieve verwijzingen
  • 2006/42/EG, Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen