Norm

NEN-EN 753-3:1995 Ontw. en

Identificatiekaarten - Intersectorale dunne buigzame kaarten - Deel 3: beproevingsmethoden

  • Deze norm is ingetrokken sinds 31-01-2000

41,00

Over deze norm

Status Ingetrokken
Aantal pagina's 53
Commissie Identificatiekaarten en persoonlijke identificatie
Gepubliceerd op 01-01-1995
Taal Engels
Part 3 of EN 753 specifies the test methods and procedures required to carry out measurements of the TFC characteristics specified in EN 753-1 and EN 753-2. Many of the standard methods available for checking physical properties of base materials are intended to be applied to samples cut from continuous material or large sheets. Within the scope of this standard however, it shall be clearly understood that all requirements of the standard, unless explicity stated otherwise, apply to finished cards. The test methods described in this standard are to be performed on separate samples. It is not intended that any individual card should pas through more than one test procedure, unless explicity stated. Criteria of acceptablity do not form part of this standard. The acceptance criteria are specified in EN 753-4.

Details

ICS-code 35.240.15
Nederlandse titel Identificatiekaarten - Intersectorale dunne buigzame kaarten - Deel 3: beproevingsmethoden
Engelse titel Identification card systems - Intersector thin flexible cards - Part 3: Test methods
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen