Norm

NEN-EN 754-7:2015 Ontw. en

Aluminium en aluminiumlegeringen - Koudgetrokken staven en buizen - Deel 7: Naadloze buizen, toleranties op afmetingen en vorm

  • Deze norm is ingetrokken sinds 16-06-2016

23,50

Over deze norm

Status Ingetrokken
Aantal pagina's 16
Gepubliceerd op 01-10-2015
Taal Engels
This European Standard specifies the tolerances on dimensions and form for aluminium and aluminium alloys cold drawn seamless tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see Figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see Figure 2) supplied in straight lengths. This European Standard only applies to tube produced by the seamless die/mandrel method of extrusion (and then cold drawn to the final dimensions required). The temper designations used in this part are according to EN 515. This document applies to cold drawn, seamless tube for general engineering applications. This document does not apply to: - cold drawn tube produced by the porthole/bridge method (EN 754-8), - tubes delivered in coils (EN 13958), - coiled tubes cut to length (EN 13958).

Details

ICS-code 77.150.10
Nederlandse titel Aluminium en aluminiumlegeringen - Koudgetrokken staven en buizen - Deel 7: Naadloze buizen, toleranties op afmetingen en vorm
Engelse titel Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen