Norm

NEN-EN 847-1:2003 Ontw. en

Gereedschap voor houtbewerking - Veiligheidseisen - Deel 1: Freesgereedschap, ronde zaagbladen

  • Deze norm is ingetrokken sinds 12-05-2005

29,20

Over deze norm

Status Ingetrokken
Aantal pagina's 30
Commissie Houtbewerkingsmachines
Gepubliceerd op 01-07-2003
Taal Engels
This standard is applicable to all hazards arising from the design of tools for woodworking machines, and describes the methods for the elimination or reduction of these hazards by tool design and by the provision of information. Part 1 of the standard deals with milling tools (bore mounted, shank mounted, integrated spindle) and circular saw blades, but does not cover any hazard related to the strength of shank of shankmounted milling tools. The hazards are listed in clause 5. This standard does not apply to boring bits, eccentric single router cutters, cutters with cutting circle less than 16 mm and to tools used in rotary knife lathes and copying lathes where the hazard of ejection and contact with the tool is always prevented by a system of fixed guards and/or movable guards interlocked with guard-locking and/or self-closing guards.

Details

ICS-code 79.120.10
Nederlandse titel Gereedschap voor houtbewerking - Veiligheidseisen - Deel 1: Freesgereedschap, ronde zaagbladen
Engelse titel Tools for woodworking - Safety requirements - Part 1: Milling tools, circular saw blades
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen