Norm

NEN-EN 847-1:2005 en

Gereedschap voor houtbewerking - Veiligheidseisen - Deel 1: Freesgereedschap, ronde zaagbladen

  • Deze norm is ingetrokken sinds 12-09-2007

61,30

Over deze norm

Status Ingetrokken
Aantal pagina's 35
Commissie Houtbewerkingsmachines
Gepubliceerd op 01-05-2005
Taal Engels
This document specifies all hazards arising from the design of tools for woodworking machines, and describes the methods for the elimination or reduction of these hazards by tool design and by the provision of information. This document deals with milling tools (bore mounted, shank mounted, integrated spindle) and circular saw blades, but does not cover any hazard related to the strength of shank of shank mounted milling tools. The hazards are listed in Clause 5. This document does not apply to boring bits, eccentric single router cutters, cutters with cutting circle less than 16 mm and to tools used in rotary knife lathes and copying lathes where the hazard of ejection and contact with the tool is always prevented by a system of fixed guards and/or movable guards interlocked with guard-locking and/or self-closing guards.

Details

ICS-code 79.120.10
Nederlandse titel Gereedschap voor houtbewerking - Veiligheidseisen - Deel 1: Freesgereedschap, ronde zaagbladen
Engelse titel Tools for woodworking - Safety requirements - Part 1: Milling tools, circular saw blades
Vervangt
Vervangen door
Gewijzigd door

Winkelwagen

Subtotaal:

Ga naar winkelwagen