Norm

NEN-EN 848-1:2004 Ontw. en

Veiligheid van houtbewerkingsmachines - Freesmachines voor éénzijdige bewerking met draaiend gereedschap - Deel 1: Freesmachines met één verticale as

  • Deze norm is ingetrokken sinds 23-03-2007

41,00

Over deze norm

Status Ingetrokken
Aantal pagina's 60
Commissie Houtbewerkingsmachines
Gepubliceerd op 01-02-2004
Taal Engels
This European Standard deals with all significant hazards, hazardous situations and events which are relevant to hand fed single spindle vertical moulding machines, herein after referred to as "machines", designed to cut solid wood, chip board, fibreboard, plywood and also these materials where they are covered with plastic laminate or edgings when they are used as intended and under the conditions foreseen by the manufacturer (see Clause 4). This European Standard does not apply to : a) machines equipped with outboard bearings; b) hand held woodworking machines or any adaptation permitting their use in a different mode, i.e. bench mounting. This European Standard is not applicable to hand fed single spindle vertical moulding machines which are manufactured before the date of publication of this document by CEN.

Details

ICS-code 79.120.10
Nederlandse titel Veiligheid van houtbewerkingsmachines - Freesmachines voor éénzijdige bewerking met draaiend gereedschap - Deel 1: Freesmachines met één verticale as
Engelse titel Safety of woodworking machines - One side moulding machines with rotating tool - Part 1: Single spindle vertical moulding machines
Vervangt
Vervangen door
Normatieve verwijzingen
  • 2006/42/EG, Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen