Norm

NEN-EN 848-3:2004 Ontw. en

Veiligheid van houtbewerkingsmachines - Freesmachines voor éénzijdige bewerking met draaiend gereedschap - Deel 3: Numeriek bestuurde boor- en freesmachines

  • Deze norm is ingetrokken sinds 17-04-2007

41,00

Over deze norm

Status Ingetrokken
Aantal pagina's 64
Commissie Houtbewerkingsmachines
Gepubliceerd op 01-02-2004
Taal Engels
This European Standard deals with all significant hazards, hazardous situations and events which are relevant to NC boring machines and NC routing machines (as defined in Clause 3.1.1) herein after referred to as "machines" designed to cut solid wood, chip board, fibreboard, plywood and also these materials where these are covered with plastic laminate or edgings when they are used as intended and under the conditions foreseen by the manufacturer (see clause 4). This European standard does not deal with the specific hazards of edge banding units fitted to NC boring and routing machines. This standard is not applicable to single spindle hand fed/ integrated fed routing machines which are dealt with in EN 848-2:1997 This standard is not applicable to NC boring machines and NC routing machines which are manufactured before the date of publication of this document by CEN.

Details

ICS-code 79.120.10
Nederlandse titel Veiligheid van houtbewerkingsmachines - Freesmachines voor éénzijdige bewerking met draaiend gereedschap - Deel 3: Numeriek bestuurde boor- en freesmachines
Engelse titel Safety of woodworking machines - One side moulding machines with rotating tool - Part 3: Numerical control (NC) boring machines and routing machines
Vervangt
Vervangen door
Normatieve verwijzingen
  • 89/336/EEG, Elektromagnetische compatibiliteit

Winkelwagen

Subtotaal:

Ga naar winkelwagen