Norm

NEN-EN-IEC 60695-2-11:2014 en

Brandbaarheid van elektrotechnische producten - Deel 2-11: Beproevingsmethoden met gloeidraad/hete draad - Gloeidraadbrandbaarheidsproef op eindproducten (GWEPT)

63,40

Over deze norm

Status Definitief
Aantal pagina's 30
Commissie Brandbaarheid
Gepubliceerd op 01-07-2014
Taal Engels
NEN-EN-IEC 60695-2-11 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard. This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard analysis, the flammability aspects and the flame spreading to other products are not covered by the present standard. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Details

ICS-code 13.220.40
29.020
Nederlandse titel Brandbaarheid van elektrotechnische producten - Deel 2-11: Beproevingsmethoden met gloeidraad/hete draad - Gloeidraadbrandbaarheidsproef op eindproducten (GWEPT)
Engelse titel Fire hazard testing - Part 2-11: Glowing/hot-wire based test methods - Glow-wire flammability test method for end-products (GWEPT)
Vervangt
Normatieve verwijzingen
  • 2006/95/EG, Laagspanningsrichtlijn nieuw

Winkelwagen

Subtotaal:

Ga naar winkelwagen