Norm

NEN-EN-IEC 61300-3-35:2010 en

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Fibre optic connector endface visual and automated inspection

  • Deze norm is ingetrokken sinds 02-11-2015

117,74

Over deze norm

Status Ingetrokken
Aantal pagina's 21
Commissie Fibre optic communications
Gepubliceerd op 01-02-2010
Taal Engels
This part of IEC 61300 describes methods for quantitatively assessing the endface quality of a polished fibre optic connector. The information is intended for use with other standards which set requirements for allowable surface defects such as scratches, pits and debris which may affect optical performance. In general, the methods described in this standard apply to 125 μm cladding fibres contained within a ferrule and intended for use with sources of ≤2 W of input power. However, portions are applicable to non-ferruled connectors and other fibre types. Those portions are identified where appropriate.

Details

ICS-code 33.180.20
Nederlandse titel Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Fibre optic connector endface visual and automated inspection
Engelse titel Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Fibre optic connector endface visual and automated inspection
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen