Norm

NEN-EN-IEC 61300-3-35:2015 en

Glasvezel communicatie - Glasvezel verbindingsapparatuur en passieve componenten - Fundamentele test- en meetprocedures - Deel 3-35: Onderzoeken en metingen - Visuele inspectie van glasvezelconnectoren en 'fibre-stub transceivers'

117,74

Over deze norm

Status Definitief
Aantal pagina's 42
Commissie Fibre optic communications
Gepubliceerd op 01-11-2015
Taal Engels
NEN-EN-IEC 61300 describes methods for quantitatively assessing the end face quality of a polished fibre optic connector or of a fibre optic transceiver using a fibre-stub type interface. Sub-surface cracks and fractures are not considered in this standard. In general, the methods described in this standard apply to 125 μm cladding fibres contained within a ferrule and intended for use with sources of ≤ 2 W of input power. However, portions are applicable to non-ferruled connectors and other fibre types. Those portions are identified where appropriate. It is not the intention of this standard that the size of scratches should be measured, the dimensions and requirements are selected such that they can be estimated. There is no need to measure for example if a scratch is 2,3 μm wide.

Details

ICS-code 33.180.20
Nederlandse titel Glasvezel communicatie - Glasvezel verbindingsapparatuur en passieve componenten - Fundamentele test- en meetprocedures - Deel 3-35: Onderzoeken en metingen - Visuele inspectie van glasvezelconnectoren en 'fibre-stub transceivers'
Engelse titel Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Visual inspection of fibre optic connectors and fibre-stub transceivers
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen