Over deze norm
||Cables, wires, waveguides, R.F. connectors, R.F. and microwave passive components and accessoires
This part of IEC 61935 specifies reference measurement procedures for cabling parameters and the requirements for field tester accuracy to measure cabling parameters identified in ISO/IEC 11801. References in this standard to ISO/IEC 11801 mean ISO/IEC 11801 or equivalent cabling standards. This standard applies when the cable assemblies are constructed of cables complying with IEC 61156 -1, IEC 61156-2, IEC 61156-3 IEC 61156-4, IEC 61156-5 or IEC 61156-6, and connecting hardware as specified in IEC 60603-7 or IEC 61076-3-104. In the case where cables and/or connectors do not comply with these standards then additional tests may be required. This standard is organized as follows: - reference laboratory measurement procedures are specified in Clause 4. In some cases, these procedures may be used in the field; - descriptions and requirements for measurements in the field are specified in Clause 5; - performance requirements for field testers and procedures to verify performance are specified in Clause 6.