Norm

NEN-EN-IEC 62040-3:2011 en

Ononderbroken voedingen - Deel 3: Methode voor de specificatie van de prestatie- en beproevingseisen

280,76

Over deze norm

Status Definitief
Aantal pagina's 106
Commissie Vermogenselektronica
Gepubliceerd op 01-07-2011
Taal Engels
This International Standard applies to movable, stationary and fixed electronic uninterruptible power systems (UPS) that deliver single or three-phase fixed frequency a.c. output voltage not exceeding 1 000 V a.c. and that incorporate an energy storage system, generally connected through a d.c. link. This standard is intended to specify performance and test requirements of a complete UPS and not of individual UPS functional units. The individual UPS functional units are dealt with in IEC publications referred to in the bibliography that apply so far that they are not in contradiction with this standard. The primary function of the UPS covered by this standard is to ensure continuity of an a.c. power source. The UPS may also serve to improve the quality of the power source by keeping it within specified characteristics. UPS have been developed over a wide range of power, from less than hundred watts to several megawatts, to meet requirements for availability and quality of power to a variety of loads. Refer to Annexes A and B for information on typical UPS configurations and topologies. This standard also covers UPS test and performance when power switches form integral part of a UPS and are associated with its output. Included are interrupters, bypass switches, isolating switches, and tie switches. These switches interact with other functional units of the UPS to maintain continuity of load power.

Details

ICS-code 29.200
Nederlandse titel Ononderbroken voedingen - Deel 3: Methode voor de specificatie van de prestatie- en beproevingseisen
Engelse titel Uninterruptible power systems (UPS) - Part 3: Method of specifying the performance and test requirements
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen