Norm

NEN-EN-IEC 62329-3-102:2010 en

Gegoten krimpvormen - Deel 3: Specificatie-eisen voor afmetingen van de vorm, materiaaleisen en compatibiliteitprestaties - Blad 102: Gegoten krimpvormen van elastomeer, halfstijve, materiaaleisen en systeemprestatie

36,23

Over deze norm

Status Definitief
Aantal pagina's 14
Commissie Isolatiesystemen
Gepubliceerd op 01-10-2010
Taal Engels
This sheet of IEC 62329-3 gives the requirements for heat-shrinkable elastomeric moulded shape, semi-rigid material requirements and system performance. Experience of product performance indicates that this moulded shape material is suitable for inclusion in systems for operation in the following temperature ranges: -75 °C to + 120 °C. The moulded shapes may be supplied with a pre-coated adhesive. Refer to the manufacturers/suppliers for options. A guide to adhesive compatibility is given in Annex A. These moulded shapes are normally supplied in the styles and dimensions given in IEC 62329-3- 100. The colour is normally Black. Styles and dimensions other than those specifically listed in IEC 62329-3-100 may be available as custom items. These items shall be considered to comply with this standard if they comply with the property requirements listed in Table 1 with the exception of dimensions. Materials that conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.

Details

ICS-code 29.035.01
Nederlandse titel Gegoten krimpvormen - Deel 3: Specificatie-eisen voor afmetingen van de vorm, materiaaleisen en compatibiliteitprestaties - Blad 102: Gegoten krimpvormen van elastomeer, halfstijve, materiaaleisen en systeemprestatie
Engelse titel Heat-shrinkable moulded shapes - Part 3: Specification requirements for shape dimensions, material requirements and compatibility performance - Sheet 102: Heat-shrinkable elastomeric moulded shapes, semi-rigid, material requirements and system performance

Winkelwagen

Subtotaal:

Ga naar winkelwagen