Norm

NEN-EN-ISO 10360-5:1998 Ontw. en

Geometrische productspecificaties (GPS) - Driedimensionale meetmachines - Deel 5: Prestatieproeven voor DMM's gebuikt in opstelling met meer tasters

  • Deze norm is ingetrokken sinds 01-07-1999

17,55

Over deze norm

Status Ingetrokken
Aantal pagina's 8
Commissie Productgeometrie
Gepubliceerd op 01-08-1998
Taal Engels
Specifies the acceptance test which verifies that the performance of a CMM used with multiple styli in discrete-point probing is as stated by the manufacturer. It also specifies the reverification test which enables the user to periodically reverify the performance of a CMM used with multiple styli in discrete-point probing. The acceptance test and reverification test described in this standard are applicable only to: - CMMs using any type of contacting probing systems; - configurations of the stylus system which can be pre-qualified, i.e. where the repeatability of the system operation is sufficient not to require qualification of a stylus every time it is used.

Details

ICS-code 17.040
17.040.30
Nederlandse titel Geometrische productspecificaties (GPS) - Driedimensionale meetmachines - Deel 5: Prestatieproeven voor DMM's gebuikt in opstelling met meer tasters
Engelse titel Geometrical Product Specifications (GPS) - Coordinate measuring machines - Part 5: Performance test for CMMs used with multiple stylus setups
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen