Norm

NEN-EN-ISO 10414-2:2005 Ontw. en

Aardolie- en aardgasindustrie - Beproeving in het veld van boorvloeistoffen - Deel 2: Op olie gebaseerde vloeistoffen

  • Deze norm is ingetrokken sinds 23-06-2011

58,21

Over deze norm

Status Ingetrokken
Aantal pagina's 104
Commissie Gas- en oliewinning en -productie
Gepubliceerd op 01-12-2005
Taal Engels
This part of ISO 10414 provides standard procedures for determining the following characteristics of oil-based drilling fluids: a) drilling fluid density (mud weight); b) viscosity and gel strength; c) filtration; d) oil, water and solids contents; e) alkalinity, chloride content and calcium content; f) electrical stability; g) lime and calcium contents, calcium chloride and sodium chloride contents; h) low-gravity solids and weighting material contents. Annexes A, B, C, D, H, I, K and L provide additional test methods that may optionally be used for the determination of i) shear strength, j) oil and water contents from cuttings, k) drilling fluid activity, l) aniline point, m) cuttings activity, n) active sulfides. o) PPA test method for cells with set screws. p) PPA test method for cells with screw-on caps. Annexes F, G and J provide procedures that may optionally be used for q) sampling, inspection and rejection, r) rig-site sampling, s) calibration and verification of glassware, thermometers, viscometers, retort kit cups and drilling fluid balances. Annex E provides examples of calculations for t) lime, salinity and solids content. Annex M contains an example of a drilling fluid report form.

Details

ICS-code 75.180.10
Nederlandse titel Aardolie- en aardgasindustrie - Beproeving in het veld van boorvloeistoffen - Deel 2: Op olie gebaseerde vloeistoffen
Engelse titel Petroleum and natural gas industries - Field testing of drilling fluids - Part 2: Oil-based fluids
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen