Norm

NEN-EN-ISO 1133-1:2011 en

Kunststoffen - Bepaling van de smeltindex op basis van volume (MVR) en de smeltindex op basis van massa (MFR) van thermoplastische materialen - Part 1: Algemene methoden

106,87

Over deze norm

Status Definitief
Aantal pagina's 24
Commissie Kunststoffen
Gepubliceerd op 01-12-2011
Taal Engels
This part of ISO 1133 specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. Procedure A is a mass-measurement method. Procedure B is a displacement-measurement method. Normally, the test conditions for measurement of melt flow rate are specified in the material standard with a reference to this part of ISO 1133. The test conditions normally used for thermoplastics are listed in Annex A. The MVR is particularly useful when comparing materials of different filler content and when comparing filled with unfilled thermoplastics. The MFR can be determined from MVR measurements, or vice versa, provided the melt density at the test temperature is known. This part of ISO 1133 is also possibly applicable to thermoplastics for which the rheological behaviour is affected during the measurement by phenomena such as hydrolysis (chain scission), condensation and crosslinking, but only if the effect is limited in extent and only if the repeatability and reproducibility are within an acceptable range. For materials which show significantly affected rheological behaviour during testing, this part of ISO 1133 is not appropriate. In such cases, ISO 1133-2 applies.

Details

ICS-code 83.080.20
Nederlandse titel Kunststoffen - Bepaling van de smeltindex op basis van volume (MVR) en de smeltindex op basis van massa (MFR) van thermoplastische materialen - Part 1: Algemene methoden
Engelse titel Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen